Bentel B-TEL99 - Option 2) Number of Call Cycles

nel 1; b-b-3 e the Short Common Message assigned to both alarm
channels (16 seconds).
Default setting The default setting is 2.
Access the programming phase ...
1
Press a. a
è
2
Press b. b
è
3
Press 1. 1
è
4
Press 1, 2 or 3, for example 1 ... 1
è
5
Press e to confirm and quit. e
è
Option 2) Number of call cycles
The call cycle option establishes the number of times the call cycle must
be repeated.
+
If alarm channel 1 goes into alarm status during the alarm channel 2 cy-
cles, the latter will be interrupted by the programmed cycles for alarm
channel 1 (priority channel), the remaining alarm channel 2 cycles will re-
start when alarm channel 1 cycles end.
The B-TEL99 may be programmed to carry out 1, 2, 3, 4 or 5 call cycles.
Default setting The default setting is 4 call cycles.
To set the required number of call cycles proceed as follows.
Access the programming phase ...
1
Press a. a
è
2
Press b. b
è
3
Press 2 (option number). 2
è
4
Enter the required number of call cycles by pressing
the corresponding key (1 to 5), for example 2 ...
2
è
5
Press e to confirm and quit. e
è
PROGRAMMING 25