Listen-in
To Listen-in on the protected ambient (via the remote telephone called by
the dialler) proceed as follows.
Enter the User Command PIN then press [*].
+
To stop the alarm cycle/s during remote Listen-in, enter the User Com-
mand PIN followed by [#], before the dialler call ends.
The initial Listen-in time is 40 seconds.
Press [*] at any point in the message to refresh (for a further 40 seconds)
the Listen-in time.
Auxiliary The B-TEL99 has an auxiliary command which stops the alarm cycle/s,
this can be connected to an electric lock, burglar control panel, radio re-
ceiver or other similar devices. The installer will enable this command if re-
quired.
ATTENTION Qualified persons only should install and program the
B-TEL99, if proper functioning is to be guatanteed.
To Previous Page
Loading...