Bentel B-TEL99 - Option 3) Message Playback Time; Option 4) Dialling Type

Option 3) Message playback time
The message playback time option establishes the length of time (20, 40,
60 or 80 seconds) that the message must run for each telephone number.
+
The message playback time should not be confused with the alarm mes-
sage length, in fact, the latter is specified in option 1. The above value
(length in seconds) will allow the message to be played several times.
+
If option 1 is set as "Short Common Message + 2 brief dedicated mes-
sages", and value 3 is set, the message length will be 8+16=24 seconds,
and will run for 60 seconds, that is, two and a half times: 60:24= 2.5 times.
Default setting The default message playback time is 40 seconds.
To set the message playback time proceed as follows.
Access the programming phase ...
1
Press a. a
è
2
Press b. b
è
3
Press 3. 3
è
4
Enter the required message playback time by
pressing one of the following keys:
1 = 20 s; 2 = 40 s; 3 = 60 s; 4 =80 s.
If 40 seconds is required select 3...
3
è
5
Press e to confirm and quit. e
è
Option 4) Dialling type
It is possible to select pulse or DTMF dialling, according to the local dialling
type, however, when possible select DTMF as it is faster than pulse dialling.
Default setting The default setting is for DTMF.
26 Telephone dialler B-TEL99