INTRODUCTION
General features
Dialler r 2 independent alarm channels with priority management.
r Message choices:
Long Common Message of 32 seconds (common to both channels);
Two Dedicated Messages of 16 seconds (one message per channel);
Short Common Message of 16 seconds (common to both channels)
+ 2 Brief Dedicated Messages of 8 seconds (one per channel).
r 255 event logger, each event shows: called telephone number, the trigger
channel and call result.
r Stop alarm cycle/s and Listen-in via remote telephone, by means of modifi-
able User Command PIN.
r Stop Alarm by means of modifiable User Command PIN on B-TEL99 key-
pad.
r 7 programmable telephone numbers for each channel.
r Up to 15 digits per telephone number; pauses of 1 or 5 seconds may be
entered.
r Repeats the alarm message for 20, 40, 60 or 80 seconds.
r Repeats call cycle/s up to 5 times.
r Stop alarm cycle/s terminal.
r Access to programming by means of modifiable Installer Command PIN on
keypad.
r Programmable alarm-call activation by positive drop or negative command.
r "Voice answer detection" option.
r Protection against accidental battery polarity inversion.
Telephone line r Test for telephone-line fault and cutting, with anomaly signalling on open-
collector output.
r Bypassable "dial tone" check.
r Electronic telephone-line interface.
r Over-voltage protection.
r Programmable as DTMF (tone) or pulse dialling.
INTRODUCTION 5
To Next Page
Loading...