49 Bentone
17.5 Operation of the program controller
The program is canceled in the event of a power failure.
H
The program controller will only function if
- the program controller function has been configured ( Fnct = 1 ...4)
- the program setpoints (SPP1 ... SPP8) and
segment times (tP 1 ... tP 8) have been entered
Normal display
Program is running
(the symbol for ramp appears)
Program pause
h Alter the present
setpoint with
I and D
The controller controls to
the present setpoint.
(The value is accepted
automatically after 2 sec.)
When the program is
paused, the lower display
blinks.
Alter setpoint
To Next Page
Loading...
