6 172 155 16 07-01
DESCRIPTION
Warning
- Read the manual before assembling or commissioning.
- The contents of this manual are to be observed by all who work for any
reasoN on the unit and its appertaining system parts.
- This manual is intended especially for authorised personnel.
- This manual is to be regarded as part of the burner and shall always be
available near the place of installation.
- The burner is only to be installed by qualified personnel
- Check that the burner is suitable for the boiler´s power range.
- The burner is to be installed such that it complies with any local
regulations relating to electrical safety, boilers and fuel distribution.
- Check that the burner is approved for the gas quality intended used.
- No burner safety systems are to be disengaged.
- The fitter is to ensure that the boiler room is supplied with fresh air
ventilation that is sufficient in accordance with local standards.
- Before servicing, shut off the fuel supply and the power supply to the
burner.
- The outer temperature of the boiler´s components can exceed 60 °C.
- Check that the guide stop is installed before servicing.
- Take great care when servicing. Trap and pinch risks can be present.
- The boiler´s sound level can exceed 85 dBA during operation. Use ear
protectors when present in the boiler room.
- The electrical installation shall be made according to valid regulations
for heavy current and in a professional way, so that the risk of leaking
gas, fire or personal injury is avoided.
- If another electrical connection is used than the one recommended by
Enertech, there might be a risk of material damage or personal injury.
- Notice should be carefully taken by the installer that no electrical cables
or gas pipes get squeezed or damaged when installing or at service
- If the boiler is provided with an opening door, this should be interlocked
with a door switch.
- Ensure that everything is delivered and that there is no transport
damage.
- If there is anything wrong with the delivery, please report it to the supplier.
- Any transport damage should be reported to the forwarding company.
- Ensure that the size and capacity range of the burner are suitable for
the boiler.
- Power data on the data plate refer to the minimum and maximum power
of the burner.
!
Warning
Safety directions
Acceptance inspection
Preparations for installation
To Next Page
Loading...
