Bernette B05 Academy - Adjusting the Presser Foot Pressure

Sewing preparation
24
2020-09 EN 5220205.00A.04
> Carefully lower the presser foot lifter until the notch in the shaft engages with the presser foot sole pin.
1
2
Removing and inserting the presser foot holder
Prerequisite:
• The presser foot sole is removed.
> Raise the presser foot.
> Align the presser foot holder (1) with the presser foot bar (2) underneath and to the left.
> Hold the presser foot holder firmly and screw in the screw by hand.
> Tighten the screw using the screwdriver.
1
2
Inserting the edge/ quilting guide
The seam guide is suitable for sewing parallel lines.
> Insert the seam guide (1) into the hole in the presser foot holder (2).
> Set the required distance to the adjacent seam.
1
2
2
Adjusting the presser foot pressure
The presser foot pressure is designed to adjust the pressure of the presser foot optimally to the fabric
thickness. When working with thick fabrics, it is recommended to reduce the presser foot pressure. This
provides the advantage that the presser foot is slightly lifted so that the fabric can be moved more easily.
When working with thin fabrics, it is recommended to increase the presser foot pressure. This provides
the advantage that the fabric cannot be moved too easily under the presser foot.
> To increase the presser foot pressure, turn the «Presser foot pressure» adjustment knob clockwise.