Creative sewing
40
2020-09 EN 5220205.00A.04
3.4 Securing
Securing the seam at the start
> Select the stitch pattern.
> Sew the seam forwards for a few stitches.
> Press and hold the reverse sewing lever.
> Sew backwards along the seam to the start of the seam.
> Release the reverse sewing lever so that the machine starts sewing forwards.
– The start of the seam is now secure.
Securing the seam at the end
> Sew forwards using the selected stitch pattern to the end of the seam.
> Press and hold the reverse sewing lever.
> Sew the seam backwards for a few stitches.
> Release the reverse sewing lever.
> Sew along the seam again to the end of the seam.
– The end of the seam is now secure.
3.5 Sew thick areas
> Fit the zigzag foot.
– The black knob on the right-hand side of the presser foot locks the presser foot in a horizontal
position if it is pressed in before lowering the presser foot (1). This ensures even feeding at the
beginning of a seam and helps when sewing multiple layers of fabric such as sewing over seams when
hemming jeans.
> Once the highest point has been reached, lower the needle and raise the presser foot.
> Press the foot tip and the black knob, lower the presser foot and continue sewing.
– The black button releases automatically after sewing few stitches.
To Next Page
Loading...
