Sewing preparation
34
2020-09 EN 5220205.00A.04
> Insert a new bobbin so that the thread is wound anti-clockwise.
> Press gently on the bobbin.
> Follow the arrow markings to bring the thread into the bobbin thread guide.
> To cut off excess thread, take the end of the thread and pull it over the thread cutter (1).
> Attach the bobbin cover.
Pulling up the bobbin thread
> Raise the presser foot and hold the needle thread gently in your left hand.
> Turn the handwheel slowly anti-clockwise until the needle is lowered. Continue turning the handwheel
until the thread take-up lever is at its highest point.
To Next Page
Loading...
