Sewing preparation
33
2020-09 EN 5220205.00A.04
> Cut the end of the thread above the inner hole.
> To continue the winding process, press the foot control.
> Release the foot control to stop the winding process.
> Push the bobbin winding unit to the left into the starting position.
– The machine switches to sewing mode.
> Remove the bobbin and cut the thread.
Threading the bobbin thread
NOTICE
Needle breakage caused by unevenly wound bobbins
Unevenly wound bobbins can lead to incorrect thread tension or cause needles to break.
> Only use evenly wound bobbins.
Prerequisite:
• The needle is raised.
• The presser foot is raised.
• The machine is switched off.
> To open the bobbin cover, push the handle to the right and remove the bobbin cover.
To Next Page
Loading...
