Bernette b48 FUNLOCK - Page 25

24
– While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs (3).
– Turn the handwheel toward you until the lower
looper extends out 5–10 mm from the stitch
plate edge.
– Thread the looper area of the machine following
the red color coded thread guides (4)–(9).
– Place the thread with the point of the tweezers
slightly from left and to the right of threading
guide (4).
– Thread the looper eye (A) from front to back.
– Pull about 10 cm (4 inches) of thread.
– Position thread into V cutout (B) on threader.
– Firmly hold thread tail with left hand and pull
Threader lever (C) up into place (D).
9
8
A
B
C
D
3
9
8
4
5
5
6
7
4
5
5
6
7
8
9
4
3
9
8
A
B
C
D
3
9
8
4
5
5
6
7
4
5
5
6
7
8
9
4
3
9
8
A
B
C
D
3
9
8
4
5
5
6
7
4
5
5
6
7
8
9
4
3
9
8
A
B
C
D
3
9
8
4
5
5
6
7
4
5
5
6
7
8
9
4
3
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.