Bernette b48 FUNLOCK - How to Sew a Rolled Hem

 57
R
N
R
3
2
1
R
N
R
3
2
1
R
N
R
3
2
1
R
N
R
3
2
1
HOW TO SEW A ROLLED HEM
– This machine can sew three types of rolled
hems.
– Rolled hemming is done by rolling and
overedging the fabric edge.
– Light weight fabrics such as lawn, voile, organdy,
crepe, etc. perform the best.
– Rolled hemming is not suited for heavy or stiff
fabrics.
Machine set up
– Remove the overlock left needle.
– Move seam width finger knob to setting "R".
– Align left face of seam width finger support
plate with "R" mark on stitch plate by turning
cutting width dial, as required.
– Set stitch length dial to 1–2 and a fine seam will
be sewn.
Needle:
ELx705
Thread:
A variety of thread combinations can be used for rolled
hemming.
PLEASE NOTE:
Rolled hemming can only be performed with the
overlock right needle.
CAUTION:
Be sure to turn off power switch.