Bernette b48 FUNLOCK - Threading the Overlock Left Needle (Yellow)

28
Threading the Overlock Left Needle
(Yellow)
(A On Needle Clamp)
– Continue to thread points (4)–(10).
– Raise the presser foot to open the tension
discs.
– Thread the left needle as indicated (1)–(10).
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
Before threading eye of needle, slip thread behind
thread guide (9) located on the bottom of the needle
holder.
– Thread the eye of the right needle (10).
1
2
2
3
6
7
8
9
5
4
10
3
8
4
5
7
6
3
2
9
10
1
1
2
2
10
9
8
4
5
7
6
3
2
9
10
1
1
2
2
10
9
8
4
5
7
6
3
2
9
10
1
1
2
2
10
9
CAUTION:
Be sure to turn off power switch.
PLEASE NOTE:
Slip the thread into the rear slot on the thread
guide (5)and into the slot on the take-up lever
cover (6). Then slip the thread into the right slot
on the thread guides (7) and (8).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
– Pass thread from back to the front through the
thread guide (1).