Bernette b48 FUNLOCK - Page 30

 29
– Continue to thread points (4)–(10).
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
Before threading eye of needle, slip thread behind
thread guide (9) located on the bottom of the needle
holder.
– Thread the eye of the left needle (10).
3
7
6
4
8
9
5
10
10
9
3
PLEASE NOTE:
Slip the thread into the middle slot on the thread
guide (5) and into the slot on the take-up lever
cover (6).
Then slip the thread into the middle slot
on the thread guides (7) and (8).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
8
4
5
7
6
3
2
9
10
1
1
2
2
10
9
3
7
6
4
8
9
5
10
10
9
3
3
7
6
4
8
9
5
10
10
9
3
– Thread the pre-tension guide by pulling the
thread towards the right until it slips under guide
(2). Then pull thread along the right side of pre-
tension as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs (3).