64
– Fold the fabric with the wrong sides together
and sew.
– Press the pin tucks in the same direction.
PLEASE NOTE:
Presser foot has been removed to show detail.
How to turning Square Corners
• Outside Corner
– Cut out approximately 2 cm (51/64 inch) from
the corner, in line with the overlock seam edge.
– Turn the fabric and lower the presser foot so
that the upper knife is positioned in line with the
cut edge.
– Pull slack threads up, then start to sew.
– Sew one stitch beyond point (A) and stop.
– Raise needle and presser foot.
– Pull the fabric to the rear of the machine just
enough to release the thread caught on the
finger of the stitch plate.
To Next Page
Loading...
