Bernette b48 FUNLOCK - Center Coverstitch;Chainstitch Needle (Green)

 31
9
10
10
10
9
10
10
10
– Continue to thread points (4)–(10).
Before threading the eye of the needle, make sure
thread is in front of thread guide located on the bottom
of the needle holder (9).
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
– Thread the eye of the right needle (10).
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5) and bottom slot of take-up lever cover (6).
Then slip thread into the right slot on the thread
guide (7), and into the right slot on the thread
guide (8).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
• Center Coverstitch/Chainstitch Needle
(Green)
(D On Needle Clamp)
– Raise the presser foot to open the tension
discs.
– Thread the center coverstitch/chainstitch
needle as indicated (1)–(10).
9
10
10
10
CAUTION:
Be sure to turn off power switch.