Sewing preparation
34
2.7 Presser foot
Adjusting the presser foot position via the knee lifter of the Free Hand System
> Adjust the sitting height so that the knee lifter can be operated with the knee.
> Push the knee lifter with the knee to the right to raise the presser foot.
– Simultaneously the feed dog is lowered and the thread tension is released.
> Release the knee lifter slowly to lower the presser foot.
Changing the presser foot sole
Removing the presser foot sole
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Push the button at the snap-on shaft.
– The presser foot sole is released.
Attaching the presser foot sole
> Place the presser foot sole beneath the shaft so that the cross pin is beneath the opening of the shaft.
To Next Page
