Bernina 475 QE - Cord; Using Cord with the Buttonhole Foot #3

Buttonholes
91
9.5 Cord
Using cord with the Buttonhole Foot#3
Prerequisite:
• The Buttonhole Foot#3 is fitted and raised.
> Insert the needle at the beginning of the buttonhole.
> Hook the cord over the center pin at the front of the Buttonhole Foot.
> Pull both cords ends under the Buttonhole Foot to the back and place each a cord into a groove of the
sole.
> Lower the Buttonhole Foot.
> Sew the buttonhole in the usual manner.
> Pull the cord loop until the loop disappears in the bartack.