Decorative stitches
85
> Pull the cord through the hook opening from the bottom and through the opening of the stitch plate.
> Replace the stitch plate.
> Close the Looper cover.
> Make sure that the cord slides through the thread slot of the bobbin cover.
> Place the spool on the spool holder.
> Check that the cord runs smoothly.
> If the thread doesn't glide smoothly at the hook cover, leave the hook cover open.
– The cord lies on the wrong side of the material and is hold/sewn over by the bobbin thread.
Sewing Pintucks
> Insert the corresponding twin needle.
> Threading the double needle.
> Thread-up command.
> Sewing the first pintuck.
> Place the first pintuck in one of the side grooves in the presser foot.
> Sew additional pintucks parallel.
To Next Page
Loading...
