Sewing preparation
39
> At the marking on the rear of the stitch plate, push the stitch plate downwards until it tips.
> Remove the stitch plate.
> Place the openings of the new stitch plate above the corresponding guide pins and press down until it
clicks into place.
Selecting the stitch plate in the User Interface
After changing the stitch plate, you can check whether this can be used with the selected needle.
> Tap «Stitch Plate/Needle Selection».
> Select the previously attached the stitch plate.
– If the selected stitch plate is suitable to be used in combination with the needle, sewing can begin.
– If the selected stitch plate is not suitable to be used in combination with the needle, an error message
is displayed and the machine is automatically prevented from starting.
2.9 Threading
Threading the upper thread
Preparing the threading
> Place the foam pad on the spool holder.
> Place the thread spool on the spool holder so that the thread unwinds clockwise.
> Add the appropriate spool disc.
> Switch on the machine and wait until it starts up.
> Raise the needle and presser foot.
To Next Page
