Bernina 700D - WRAPPED EDGE

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/68
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
Fabric: Heavy wool or polar fleece, 5” x 6”
Needle: 80/12 Stretch
Thread: 1 cone of serger thread
1 cone of Jeans Stitch
®
Presser Foot: Standard
WRAPPED EDGE
• Owner’s manual pg.___
• Attach the 2-thread adapter to the upper looper. Note: This is an optional accessory for the 700D.
• Following the instructions in the Owner’s manual thread the serger for a 2-thread wrapped edge
using Jeans Stitch
®
thread in the lower looper. Set tension levers as directed.
• Place the fabric under the presser foot and serge along one edge; adjust the differential feed
function if needed.
• If the Jeans Stitch
®
does not wrap, the thread tension may be too tight. Reduce the looper thread
tension. If the thread still does not wrap, remove the Jeans Stitch
®
thread from the uppermost
thread guide and try again. Wrap-stitch the other three edges of the fabric.
• Use seam sealant to seal the stitching at the corners. When the sealant is dry, trim the thread tails.
• Return stitch length and thread tension levers to normal.
• Trim and mount the sample.