Bernina 700D - MULTI-PURPOSE FOOT Creating and Attaching Corded Piping

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/70
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
MULTI-PURPOSE FOOT
Creating and Attaching Corded Piping
• Owner’s manual pg.___
• Following the instructions in the Owner’s manual thread the serger for a 4-thread overlock stitch using
both needles.
• Set all thread tension levers to normal (3-5).
• Set stitch length to 3mm.
• Attach the Attachment Base.
• Attach the Multi-Purpose Foot and Guide following the directions in the instruction manual for the
Multi-Purpose Foot with Guide.
• Place the 3” x 8” fabric under the foot.
• Insert the cord into the guide.
• Wrap the bias strip around the cord and place the wrapped cord in the groove under the foot and on
top of the other fabric.
• Serge, making the covered cord and attaching it to the fabric strip in one stitching.
• Press the seam allowance to the wrong side of the fabric strip.
• Mount the sample.
Fabric: Medium weight cotton bias strip, 2” x 8”
Medium weight cotton, 3” x 8”
12” of
3
/8” cotton cording
Needle: 80/12 Stretch
Thread: 4 cones of serger thread
Presser Foot: Multi-Purpose Foot with Guide (optional accessory)
Attachment Base (optional)