BestCode Next Series 8 Technical Manual October 2022 Page 106 of 290
The BestCode Next Series 8 Features various pumps based on the machine type. The install instructions are the same.
Review the Configure Section for properly setting the Pump Type here.
MicroPump (88SOP & 88SHSOP only)
Sets the printer for usage with
the Diener fluid pump.
Sets the printer for usage with
the Fluid-o-Tech pump
Sets the printer for usage with
MicroPump pump.
Be familiar with proper safety information for handling fluids.
Procedure Time: 15 minutes
1. Remove the Makeup SmartFill
cup
2. Disconnect the Viscometer
cable from the main board.
To Next Page
Loading...
