BestCode Next Series 8 Technical Manual October 2022 Page 157 of 290
"FPGA Loaded: Version %ls"
Written to the event log to indicate that the version of FPGA that was loaded.
Written to the event log to indicate what version of software is running.
"Ink stir disabled while device is off!"
Displayed to prompt the user to confirm the request to shutdown the printer, despite the fact that Ink
Stirring is enabled.
Press OK to delete the message
Press Cancel to close the prompt.
Written to the event log to indicate that the Ink Jet has been enabled.
"Erased %d out of %d messages."
Written to the event log to indicate that some messages could not be updated from older firmware
versions and that they were deleted.
Written to the event log to indicate the number of messages that were copied from previous Firmware
after Firmware update.
"Total messages: %d; Valid messages: %d"
Written to event log to summarize the results of updating messages after Firmware update.
Written to the event log to indicate a normal shutdown.
Written to the event log to indicate that a user has either signed in or signed out using the Passwords
feature.
Displayed to prompt the user to confirm the request to reset all Counters.
Press OK to Reset all counters for the selected message
Press Cancel to close the prompt.
To Next Page
Loading...
