BestCode NExT 82 - Page 181

BestCode Next Series 8 Technical Manual October 2022 Page 167 of 290
Prompt Code
Prompt Name
Prompt Description
05-8001
USB
Memory device not detected.
Indicates that a USB drive was not detected.
Solution 1:
USB stick is bad, replace with a new stick
Solution 2:
USB is not formatted correctly, format as FAT32 and try again
Solution 3:
USB data is corrupt. Download new Firmware from Distributor portal and load onto the USB stick.
Prompt Code
Prompt Name
Prompt Description
05-8002
USB
File data not valid.
Indicates that the firmware image file was not valid.
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware.
Prompt Code
Prompt Name
Prompt Description
05-8003
-
Not Used
Solution 1:
Load Firmware.
Prompt Code
Prompt Name
Prompt Description
05-8004
Manifest
"Could not open manifest file: %ls"
Indicates that the manifest file could not be found.
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware. Do not
remove the Manifest.txt file from the USB stick.
Prompt Code
Prompt Name
Prompt Description
05-8005
Manifest
"Directory in manifest not found: %ls"
Indicates that a directory listed in the manifest could not be found.
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware. Do not
edit the Manifest.txt file.
Prompt Code
Prompt Name
Prompt Description
05-8006
Manifest
"Directory in manifest not found: %ls"
Indicates that a directory listed in the manifest file exists on the USB drive, but is not a directory
(probably a regular file).
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware. Do not
edit the Manifest.txt file.
Prompt Code
Prompt Name
Prompt Description
05-8007
Manifest
"File in manifest not found: %ls
Indicates that a file listed in the manifest could not be found.
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware. Do not
edit the Manifest.txt file.
Prompt Code
Prompt Name
Prompt Description
05-8008
Manifest
"Entry in manifest is not a file: %ls"
Indicates that a file listed in the manifest exists on the USB drive but is not a regular file (probably a
directory).
Solution 1:
Download new Firmware from Distributor portal and load onto the USB stick. Load Firmware. Do not
edit the Manifest.txt file.