BestCode NExT 82 - Page 241

BestCode Next Series 8 Technical Manual October 2022 Page 227 of 290
Wrong USB Data – 03-8006
1. If the wrong
version of
Firmware is on the
USB stick after the
firmware is
loaded, the 03-
8006 prompt will
occur.
2. Check the format on the USB stick. Make sure the version loaded on the machine matches the version loaded on
the USB stick.
Format should be as follows
>USB Drive (E:)
> 01.04.00.11 (or most current version)
>bcData
>bcTools
>Setup.exe
Correct USB file format
Wrong directory
*Pay attention
during unzip
process