KC5000 Technical manual — Remote programming 29
4 Press . The following text is displayed:
ENTER PASSWORD
5 Enter a six-digit password.
6 Press . The code is now stored. The following text is displayed again:
/
TO STEP
CHANGE PASSWORD
Press
Esc
EscEsc
Esc
to leave the Option menu and go back to stand-by position.
General information about remote programming
When you program your KC5000 from a telephone you should call the
telephone number given to your KC5000 according to the subscription.
You use the telephone’s keyboard when programming.
Proceed as follows:
1 Dial the telephone number to KC5000. When you get through you will
hear KC5000 characteristic tune.
2 Press !
!!
! and enter your password. Finish by pressing !
!!
!.
3 If you have entered the correct code, three tones in a rising sequence are
heard. If you enter the wrong code, you will hear four identical tones.
4 Program the desired functions. How this is done is described on the
following pages.
5 Finish programming by pressing #.
KC5000 characteristic tune is heard as a confirmation that programming
is completed.
6 Replace the handset.
Note! If no programming is performed within 4 minutes, the call is
automatically disconnected.
To Next Page
Loading...
