KC5000 Technical manual — Installation 7
Before starting to install the system
At the back of the manual are three charts. Make copies of the charts and ask
the system manager to fill them in according to the instructions in the
chapter Preparations.
Connecting up
To connect the different components in the code lock system, proceed as
follows: (see wiring diagram on next page).
1. Wire a 4-core cable between the central unit and each keypad.
2. Use a 2-core cable between the keypad and the electric release.
3. Use a screened 2-core cable for the printer connection.
4. If the system shall be remote programmed, then connect the telephone
line to the central unit.
5. Connect the power supply and the ground to the central unit.
6. Program time zones, codes etc. in the central unit (as described in the
Programming chapter). Use the charts that have been filled in by the
system manager.
Now the system is installed and all the information it needs to operate has
been programmed.
To Next Page
Loading...
