Bewator KC 5000 - Remote Code Programming

KC5000 Technical manual — Remote programming 33
Codes
This describes how to remote program information about New Entry,
Changing and Deleting codes.
New Entry of codes
This is how to program a new code:
1 Call up the KC5000 and enter
!
!!
! password !
!!
!.
2 Press
1 1 . Finish with !
!!
!.
3 Enter the desired four-digit code. Finish with
!
!!
!.
4 Enter the number of the door/s where the code should be valid.
Finish with
!
!!
!.
5 Enter during which time zone/s the code should be valid.
Finish with
!
!!
!.
If programming was performed correctly, three rising tones are heard,
otherwise four identical tones are heard.
6 Proceed and program other information (start from step 2) or press
#
to disconnect the call.
Example:
2 5
11
*
8
*
0 1 2
Door/s Code
0
*
1
Time zone/s
#
*
Changing codes
This is how to change a previously programmed code:
1 Call up the KC5000 and enter
!
!!
! password !
!!
!.
2 Press
1 2 . Finish with !
!!
!.
3 Enter the code to be changed. Finish with
★
★★
★.
4 Enter the new code. Finish with
!
!!
!.