Chapter5. System Configuration 37
Scroll down to Network wizard and
press 'OK' in the next screen you will get
the Welcome message for the Network
wizard, press 'OK' to start and you will
get this page>
Make sure both options are switched on
as pictured and then press 'OK'
If connection is successful you will get a
screen similar to this, please take not of
your IP address as you can use this to
access your T3 via your PC for
controlling, streaming and setting
timers. If unsuccessful please check your
network and cables or try manually
entering your network info in 'Network
settings/info' and 'Nameserver settings'
as pictured on previous page.
Wireless LAN Connection
The Beyonwiz T3 will work with a variety of wireless dongles or wireless network adapters but
we recomend the ones that are sold at www.shop.beyonwiz.com.au as they have been fully
tested and integrated.
To connect your T3 to your wireless network first place the wireless USB stick into one of the
ports on the T3 and then 'Reboot' (hold down the power button on your remote for 3
seconds and then select 'Reboot' from the power menu.
Once your T3 reboots press
The easiest way to connect to your wireless
home network is via the WLAN connection
and using the Network Wizard either in the
initial set up or by going into the Network
menu
‘Setup’
‘Network’
Once in
the Network menu select Network Adapter
Selection and press 'OK' if you then get a
choice between LAN and WLAN choose
WLAN and then pres 'OK' and you will get
this screen >
To Next Page
Loading...
