Beyonwiz T3 - 8 TV Remote Codes

Chapter8. Remote TV Codes 47
Chapter8.
TV Remote Codes
Your T3 remote control can be used to control some basic functions on your TV such as Power on/
off and volume control. Please note that not all TV brands and models are supported or any
warranty given to what features may or may not work with your TV.
REMOTE CONTROL UNIT (RCU) SETUP
Setting up as a TV Remote Control
4-digit Setting Method
In order to use the universal remote control feature, you must correctly setup for TV control. This section explains how
to setup the universal remote control. For the setting up, we have presented the list of supported TV codes.
When you press TV button, supplied remote control unit is working as TV remote controller. To do this, you have to
setup with corresponding TV codes. Valid buttons at TV mode are Power, Volume +/-, Mute, TV (for switching sources),
Menu, numeric keys (0~9), directional buttons (up/down/left/right) and colour buttons (Red/Green/Yellow/Blue).
1.
Power on TV using TV power button or TV remote control.
From this step all further remote controls should be done using the universal remote control and the remote
control should be directed towards the TV.
2.
Press and hold the TV button more than 3 seconds. Then, two LED lamps from TV and STB
buttons are flickering. Release the TV button. Then, LED lamp from the TV button is flickering.
3.
Enter 4 digits with reference to the “TV Brand List” section. If 4-digit code is in the list, LED lamp from the TV
button will flicker 3 times and corresponding 4- digit code is stored. Otherwise, TV LED lamp will turn off and
4-digit code is not stored.
NOTE: In the case that the POWER ( ) button for TV is working but other important keys are not working, then repeat the
above procedure or follow “Smart Scan Method”.
Smart Scan Method
1.
Power on TV using TV power button or TV remote control.
From this step all further remote controls should be done using the universal remote control and the remote control
should be directed towards the TV.
2.
Press and hold the TV button more than 3 seconds. Then, two LED lamps from TV and STB buttons are flickering.
Release the TV button. Then, LED lamp from the TV button is flickering.
3.
Press
▲
(up) or
▼
(down) button until TV turns off.
4.
Once TV turns off, press OK button to store current setting. Then TV LED lamp will flicker 3 times and
corresponding 4-digit code is stored.
In case that the POWER ( ) button for TV is working but other important keys are not working, then follow the above
procedure again to set different code.