BFT Espas 20I - 15 Menu 2 Programming

46 - Espas 20I
D812913 10598_02
15 - MENU 2 PROGRAMMING
Parameter Description Values Default
Input Display of the I/O state connect-
ed to the card: photocells, loops,
etc. ONLY READING
If the input is active, the corre-
sponding code is displayed (see
Values)
0=Ticket request button pressed
1=INOPZ1 input active
2=Ticket slot photocell active (only
with KPM printer)
3=INOPZ3 input active
4=Detection loop active
5=Safety loop active
6=Barrier limit switch active
7=Entry station disabling active
(terminals 12/13)
-
Language The language used by the station
is used
Change with UP and DOWN,
conrm with PUSH
To change the language, use the
EspasConfy software
IT
Address. Station conguration
Change with UP and DOWN,
conrm with PUSH
033=Entry station 1
034=Entry station 2
035=Entry station 3
033
041=Exit station 1
042=Exit station 2
043=Exit station 3
049=Table validator1
050=Table validator2
051=Table validator3
057=Counter panel 1
058=Counter panel 2
059=Counter panel 3
Gate Station type and name
Change with UP and DOWN,
conrm with PUSH
IN1...IN3 = Input 1, 2 or 3 IN 1
EXIT1...EXIT3 = Exit 1,2 or 3
POS1...POS3=Issuer 1,2 or 3
COUNT1...COUNT3 = Kit
NORA 1, 2 or 3
Warmer Thr. Express the temperature (in °C)
below which the heating resistor
is activated. Change with UP and
DOWN, conrm with PUSH
0...255 35
To enter menu 2 “ADMIN” when the station is switched on, wait for the rmware version and
the date to appear and press the joystick centrally.