BA-EN-HydroStar V3.1 page 13
5 HydroStar BGA 160/320/275/550 C for retrofit installation
• These units are ready for installation and manufactured according to order instructions.
• The frame must be securely attached to the pool edge.
• No attachment at the pool floor is necessary.
• The feet should be adjusted so that the unit stands securely and the frame is not perpendicular.
• The motor cable must be installed so that cannot be damaged.
• The installation shaft must be completely under water.
• The unit's suction is on the bottom and front side. It must be ensured that the suction slits are never
clogged and water flow is guaranteed.
NOTE
• Do not climb on the frame or the installation shaft.
• Do not use the installation shaft as a "starting block".
• Do not push-off from the cover plate.
To Next Page
Loading...