BA-EN-HydroStar V3.1 page 6
2.1.7 General safety and application notes
At the time of delivery, the counterflow unit and its components are considered to be state of the art
and fundamentally safe to operate.
All transport, storage, installation/assembly, connection, commissioning, maintenance and
servicing work may only be performed by qualified personnel.
During such work, qualified personnel must observe:
• the supplementary safety instructions in the individual chapters of this documentation.
• the safety instructions in attached supplementary sheets and further documents from
subcontractors.
• this documentation and the circuit diagrams in the control box.
• the warning and safety signs on the devices.
• the machine-specific regulations and requirements.
• the national and regional regulations for safety and accident prevention.
The counterflow unit can pose a risk to persons, the machine itself and other property
belonging to the operator
• ... if unqualified personnel work on or with the drive system.
• ... if the drive system is used improperly.
• ... if the drive system is installed and operated incorrectly.
• ... if the following notes are disregarded:
o Only operate the counterflow unit if it is in perfect working order.
o As a general rule, any retrofitting, changes or reconstruction of the drive system is prohibited.
The above work may only be performed after consultation with the manufacturer.
o During operation and for an extended period afterwards, the components may have live parts,
moving parts and hot surfaces.
o Start-up (start of proper operation) may only be carried out once it has been confirmed that the
machine complies with EMC Directive 2004/108/EC and that the machine conforms to
Machinery Directive 2006/42/EC.
o Observe EN 60204.
Should you have any questions or problems, please contact your representative.
2.1.8 Disposal
The drive unit must be disposed of in compliance with the currently applicable regulations of the
respective country. Grease and oil contained in it must be disposed of in accordance with applicable
environmental protection regulations. Electronic elements and components must be disposed of
through a certified specialised company.
2.1.9 Scope of supply
• Prewired control unit with built-in options in accordance with the specification
• Turbine with a 10m connecting cable
• Additional accessories as listed in the accompanying papers.
After receiving the delivery, check the delivery contents against the accompanying papers to make
sure they are complete.
The manufacturer does not offer warranty for claims regarding missing parts submitted at a later date.
Any transport damage that is discovered must be reported to the shipping agent without delay.
To Next Page
Loading...