Bio-Well Company
www.bio-well.com
Important Remarks and Safety Measures
User should pay special attention to the following:
• While touching the glass electrode of the Bio-Well GDV Camera device do
not touch any grounded conductive objects (like heating pipes, etc.).
• During the scanning process keep the Bio-Well GDV Camera device at least
50cm from the computer.
• Always keep the glass electrode of the Bio-Well GDV Camera device in clean
condition (using alcohol or wet tissues with alcohol – best option; if not
possible – use regular screen cleaner).
• If Bio-Well GDV Camera device was in a cold environment (less than
10ºС/50ºF) before starting using it please wait for at least 1 hour to warm
up.
• During “Environment” Scans (experiments) shifts in relative humidity
should not exceed 5% and shifts in air temperature should not exceed 5ºС.
• During “Environment” Scans do not turn on/off electrical devices within the
room where the Bio-Well GDV Camera device is operating.
• Do not use cell phones near the Bio-Well GDV Camera device or Sputnik
sensor as it can alter the result.
• Presence of different people in the room may affect the measurement
results.
• Do not take “Environment” measurements during strong atmospheric
changes as they can affect the readings.
• Be aware of changes in geomagnetic background (e.g. Sun and Moon
rise/recess, magnetic storms) during “Environment” measurements.
To Next Page
Loading...
Need help?
General