If the instructions are lost, you can ask the manufacturer, authorised dealer or service centre
for a new copy.
4. MANUFACTURER'S LIABILITY
By supplying these instructions, Biodom 27 d.o.o. declines any civil or criminal liability, both
directly and indirectly due to:
accidents that have occurred due to non-compliance with the standards and specications
set out in these instructions;
accidents caused by unauthorised and improper use by the user;
accidents caused by changes and repairs not approved by the manufacturer Biodom 27
d.o.o;
poor maintenance;
contingencies;
accidents resulting from the use of inappropriate or non-original spare parts.
The installer is fully responsible for the installation.
4.1. BASIC PREVENTIVELY REQUIRED STANDARDS
Biodom 27 A is manufactured in accordance with the following standards:
EC MACHINERY DIRECTIVE (2006/42 / EC);
EC LOW VOLTAGE EQUIPMENT DIRECTIVE (2014/35 / EC);
EC DIRECTIVE ON ELECTROMAGNETIC COMPATIBILITY (2014/30 / EC);
EC DIRECTIVE ON SOLID FUEL HEATING BOILERS UP TO A MINIMUM POWER OF 500 KW;
EN 303-5
Harmonised standards:
SIST EN ISO 12100-1: 2004 in A1: 2010;
SIST EN ISO 12100-2: 2004 in A1: 2010;
SIST EN 303-5: 2012;
61000-6-3: 2007;
61000-6-2: 2005;
61000-3-3: A1 2002;
61000-3-3: A2 2006;
EN 60204-1: 2006 and A1:2009.
4.2. TRANSPORTING AND MOVING THE PELLET BOILER
Pay attention to your safety when moving the boiler.
Before transporting and moving the boiler, which must take place in complete safety, rst make
sure that the load capacity of the transport equipment is suitable. Avoid jeerky and / or sudden
movements of the boiler.
www.biodom27.si
12 BIODOM 27A
To Next Page
Loading...