Instruction Manual TProfessional Basic 06/2011 11
3 Installation
3.1 Content of delivery
1) Thermocycler
2) Mains connector
3) Manual
4) Short Manual
Please keep the original packaging material for return shipment in case of servicing. The
TProfessional Basic shipping box provides a specially developed system for contact-free
transport of this electronic device.
3.2 Unpack and Check
Unpack and carefully examine the instrument. Report any damage to Biometra. Do not attempt
to operate this device if physical damage is present.
Please keep the original packing material for return shipment in case of service issues
!! Attention !!
Please fill out and send back the warranty registration card. This is important for you to
claim full warranty.
3.3 Installation Conditions
• Place the TProfessional Basic Thermocycler on a stable surface in a dry, safe environment.
For details see working conditions in table “Technical specifications” (see chapter 1.3).
• Let equilibrate the TProfessional Basic Thermocycler to room temperature before starting
operation (1 to 6h).
• Make sure that the appliance connector and the plug of the supply cord are accessible, so
you can separate the instrument from the mains.
• Make sure that the ventilation slots on the bottom and the rear are not obstructed (see
section 4.2). Make sure that there is no object underneath the thermocycler that may block
the ventilation slots at the bottom (e.g. a piece of paper etc.)
• There must be sufficient distance between the ventilation slots on the rear side of the
Thermocycler and a wall or another instrument (min 10 cm).
To Next Page
Loading...