Bionet BM1 - Unit Select; Troubleshooting; Check List; TEMP Message

Rev. 1.4 8.TEMPERATURE 191
BM1 User’s Manual
UNIT SELECT
Able to select unit with °C, °F.
UNIT
SELECT:
℃
ALARM
LIMIT
TEMP
MODE:
MONITOR
PROBE
SITE:
ORAL
MAIN
MENU
UNIT
SELECT:
℃
ALARM
LIMIT
TEMP
MODE:
MONITOR
PROBE
SITE:
ORAL
MAIN
MENU
8.4 TROUBLESHOOTING
Check list
4. The temperature probe(YSI 400 series) is correctly positioned on the patient.
5. Temperature cable is attached to the monitor.
6. Temperature setup is adjusted, if necessary. Follow detailed procedures within this chapter.
TEMP Message
If you experience some problems with temperature monitoring, one of the following messages
may be displayed in the TEMP parameter window.
 PROBE OFF : Probe is not properly connected. Check the probe.
- No temperature value will be displayed . Service on the monitor is required.