Rev. 1.4 5.SpO2
ALARM
Two menus: ALARM LIMIT, ALARM SOUND provided in the alarm menu
ALARM
MAIN
MENU
RATE
VOLUME:
OFF
ALARM LIMIT
Number setting of alarm value of %SpO2 is 0 ~ 100
1. Move the ▶ mark to select from RETURN, SpO2 or SpO2-R, and press.
2. After pressing at SpO2, move the cursor right or left to LOW, and press.
3. Once the color is changed, move the cursor again to the selected value and press.
4. Place the cursor to HIGH and press, when the color changes, move the cursor again to select the
targeted value, and press. Finally move to SpO2 and press.
(You may decide to perform the process in the opposite order, LOW to HIGH, to have the same
result.)
5. After pressing at SpO2-R, move the cursor right or left to LOW, and press.
6. Once the color is changed, move the cursor again to the selected value and press.
7. Place the cursor to HIGH and press, when the color changes, move the cursor again to select the
targeted value, and press. Finally move to SpO2-R and press.
8. With the selection of RETURN the user gets out of the menu.
ALARM
LIMIT
ALARM SOUND:
ON
PREV
MENU
MAIN
MENU
To Next Page
Loading...
