Rev. 1.4 1.BASIC
General Precautions on Electrical Safety
BM3 OPERATION MANUAL
Check the item listed below before operating the equipment.
NOT
1. Be sure that AC power supply line is appropriate to use. (AC100 - 240V)
2. Be sure that the power source is the one supplied from Bionet. (DC15V, 2.0A)
3. Be sure that the entire connection cable of the system is properly and firmly fixed.
4. Be sure that the equipment is completely grounded. (If not, this might cause a problem to occur in
the product.)
5. The equipment should not be placed in the vicinity of electric generator, X-ray, broadcasting
apparatus to eliminate electrical noise during operation. Otherwise, it may cause incorrect result.
The Equipment should be placed far from generators, X-ray equipment, broadcasting
equipment or transmitting wires, so as to prevent electrical noises from being generated during
the operation, When these devices are near the Equipment, it can produce inaccurate
measurements. For BM1, both independent circuit and stable grounding are essentially
required. In the event that the same power source is shared with other electronic equipment, it
can also produce inaccurate output.
Do not have contact with the patient while operating the machine It may cause serious danger
to the users. Use only the provided cable.
In case the Equipment does not operate as usual or is damaged, do not use on patient, and
contact a medical equipment technician of the hospital or the equipment supply division.
To Next Page
Loading...
