KW-231-1 19
• Enter Bluetooth password. Factory setting from firm-
ware version 2.6.58.00 on: "8670", previous ver-
sions: "2"
The CONFIGURATION menu appears with the MAIN SETUP
window. The compressor module is now connected to
the mobile device.
Fig.2: Updating the firmware
5.1 Configuration via BEST SOFTWARE
Information
For further information on operating parameter
monitoring, electrical connection and communic-
ation via BEST SOFTWARE, see Technical In-
formation KT-230.
Configuration via BEST SOFTWARE (see figure 3,
page 19)
At least the following parameters need to be set / selec-
ted in the CONFIGURATION menu:
• Compressor type.
• Refrigerants.
• Motor starter function.
• Serial number of the compressor.
Depending on the installed equipment, the following ad-
ditional parameters may have to be enabled:
• Type of start unloading.
• Additional fan.
• Liquid injection.
• CRII capacity control and the number of capacity
regulators installed.
• Monitoring of application limits.
• Low pressure and high pressure switches.
Once you have set all parameters, transfer the settings
to the device.
Fig.3: Transferring user settings to the compressor module
To Next Page
Loading...
