Example: SYST:RWL
SYSTem:ADDRess
This command reads the communication address of the power supply.
Command syntax: SYSTem:ADDRess?
Example: SYST:ADDR?
STATus:QUEStionable:ENABle
This command sets the parameter of the quest event enable register. This parameter determines which bit of
the quest event register is set to 1. If a QUES condition changes, the QUES bit of status byte register will
be set to 1.
Command syntax: STATus:QUEStionable:ENABle <parameter>
Parameter: 0~255
Reset value: Consult PSC command
Example: STAT:QUES:ENAB 110
STATus:QUEStionable:ENABle?
This query returns a value which corresponds to the binary weighted sum of all bits enabled by
STAT:QUIES:ENAB command. After this command executed, quest event enable register is reset.
Command syntax: STATus:QUEStionable:ENABle？
Return parameter: <NR1>
Example : STAT:QUES:ENAB?
STATus:QUEStionable?
This command reads parameters from the quest event register. After this command executed, quest event
register is reset.
Command syntax: STATus:QUEStionable[:EVENt]?
Return parameter: <NR1>
Example: STAT:QUES?
STATus:QUEStionable:CONDition?
This command queries the parameter of the quest condition register. When a bit value of the quest condition
parameter changes, the corresponding bit value in the quest event register will be set to 1.
Command syntax:: STATus:QUEStionable:CONDition?
Return parameter: <NR1>
Example: STAT:QUES:COND?
STATus:OPERation ENABle
This command sets the parameter of the operation event enable register. The parameter determines which bit
value of quest event register is set to 1. If a OPER condition changes, the OPER bit of the status byte
register will be set to 1.
Command syntax: STATus: OPERation:ENABle
To Next Page
Loading...
