7
/
TROUBLESHOOTING
EN
If you have a doubt about the correct functioning of your oven, this does not
necessarily mean
that
there
is a
malfunction.
In
any event,
check the
following
points:
-
The oven is not connected
to the power supply.
- Your fuse
is not working.
-
The selected
temperature
is
too low.
➡
Plug
in your oven.
➡
Replace
the fuse in your electrical
set-up and check
its
capacity
(16A).
➡
Increase the selected
temperature.
-
P
roblem with the door’s
locking mechanism.
➡
Call the
After-Sales Service
De-
partment.
The oven light is not
working.
- The
light is not working.
-
The oven is not connected
or the
fuse
is not working.
➡
Change
the bulb.
➡
Plug in your oven or
change
the
fuse.
The pyrolysis cleaning
cycle does
not begin.
-
T
he door is not properly
closed.
-
T
he locking system is
defective.
➡
Verify
that the door is locked.
➡
Call the
After-Sales Service
De-
partment.
- During
cooking.
-
At the
end
of
a
cooking cycle.
➡
The
temperature recommended
for your
choice has been
reached.
➡
Your
programmed
cooking cycle
is finished.
The cooling fan
continues to operate
after the
oven
stops.
-
The fan should work for up
to an hour after cooking, or
when
the oven
temperature
is
greater than
125°C.
-
If it
does
not stop
after 1
hour.
➡
Call the
After-Sales Service
De-
partment.
Warning
-
Repairs to your appliance should only be performed by professionals. Non-standard
repairs
may
be a source of
danger
for the user.
Tip
In all
circumstances,
if your efforts are not sufficient, contact the
After-Sales
Service
Department
without delay.