PAGE 6
OM-8003 & 8004
Date Printed: Tuesday, February 08, 2005
Revision Date: 06-12-03
WHITE MINERAL DEPOSITS
One of the byproducts of the combustion process in a gas appliance is a mineral which can show up as a white
film on the ceramic glass in the viewing door. The composition of the deposit varies widely from location to
location and also from time to time in the same locations. You may have the problem for a time and then not see
it for many months when it will reappear in your area. It seems this is associated with the varying sulfur content of
the gas. We have discussed this problem with ceramic glass manufacturers and they cannot give us a definitive
answer to this problem. We have input from several dealers who have tried various cleaning products with varying
results. We can only make the following recommendations and cannot assure you of the results in our particular
case.
WARNING!!
Never clean the ceramic glass or any other part of the appliance while it is still hot. Please shut
off your appliance and wait for it to cool down prior to cleaning.
1) Clean the glass regularly as soon as you notice the buildup (white film), if the film is left for a long period of
time to build up and bake on, it is much harder to remove and may become impossible to remove.
2) NEVER use an abrasive cleaner on the ceramic, any abrasion of the surface has an immediate effect to
lessen the strength of the glass. An emulsion type cleaner is best.
3) Use a soft damp cloth to apply the cleaner and dry the glass with a soft dry cloth, preferably cotton only. Most
paper towels and synthetic materials are abrasive to ceramic glass and should be avoided.
WHITE OFF by Rutland has been tested and qualified as being effective to remove most ugly mineral
deposits from ceramic glass.
NOTE: This is a problem beyond BLAZE KINGS control and is not covered under warranty.
BLAZE KING LIMITED LIFETIME WARRANTY
Blaze King Assurance:
Included with each gas stove manufactured by Blaze King is a Warranty Card, which must be completed in its
entirety and returned to Blaze King within ten days from the date of purchase. Blaze King will be unable to
properly administer the warranty if the card is not completed and registered on file.
This Warranty will pay to repair and or replace parts which fail under normal usage at labor rates established by
this Agreement. Extra charges such as mileage, overtime or shipping are not covered. Nuisance calls are not
covered by this Warranty. This Warranty is for residential stoves and does not apply to commercial applications.
Only failure attributed to normal usage of the electronic and mechanical functions of the stove are covered.
Failure due but not limited to, abuse, negligence, impact, fire, lightning, power failures and or surges, rust and
corrosion are not covered. Damage and or repairs to cabinets and all exterior components, remote controls, and
normal maintenance, related duct work, power surges, electrical spikes or electrical circuit overloads, filters,
knobs, glass, gaskets, block and tile etc., are not covered. Additional or unusual utility bills incurred due to any
malfunction or defect in equipment listed on this Warranty are not covered. Labor cost of gaining access to or
removal of a unit that requires special equipment or tools such as cranes, ladder trucks, etc., are not covered.
This Warranty does not include, cleaning, adjustments of the customer controls, customer product education or
any other regular service/maintenance functions. Labor, materials, expenses or equipment required to comply
with the law and or regulations set forth by any governmental agencies are not covered by this Plan.
DOOR SEAL GASKET
The front door of your new Blaze King B vent is gasketed and has been adjusted for a tight seal. With usage the
door gasket material may compress. The door may require periodic adjustment to maintain a proper seal. The
time to make this adjustment will vary depending upon individual hours of use, btu settings, and frequency of
opening and closing the door. Check the door on your appliance periodically, especially during the first 90 days of
operation, to ensure it is sealing properly. Your Blaze King dealer/installer should be contacted to properly adjust
the door if required.
To Next Page
Loading...