PAGE 8
OM-8003 & 8004
Date Printed: Tuesday, February 08, 2005
Revision Date: 06-12-03
∗ DO NOT OPERATE APPLIANCE WITH THE GLASS DOOR REMOVED, OPEN, CRACKED, OR BROKEN.
REPLACEMENT OF GLASS SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON AS
AUTHORIZED BY BLAZE KING. IF THE APPLIANCE DOOR NEEDS REPLACING IT MUST BE REPLACED AS
A COMPLETE UNIT SUPPLIED BY BLAZE KING.
∗ DO NOT USE SUBSTITUTE MATERIALS-DO NOT ABUSE GLASS BY STRIKING OR SLAMMING DOOR SHUT. DO NOT USE
ABRASIVE CLEANERS OR CLEAN WHILE HOT
∗ This appliance installation must conform with local codes and with current editions of the National Fuel Gas code ANSI Z223.1 or CAN/CGA
1-B149.
∗ The appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing of that
system at test pressures in excess of 1/2 psi (3.5 kPa)
∗ The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa). The appliance installer must provide a 1/2 inch
∗ N.P.T. plugged tapping accessibility for test gage connection immediately upstream of the gas supply connection to the appliance.
∗ Should overheating occur or the gas supply fail to shut off, shut off the manual gas valve to the appliance before shutting off the electrical
supply.
∗ 8003: If the hearth rises less than 6 inches above floor then R 1.1 or better is required at least 18 inches in front of, and spanning the width
of the unit. This appliance is equipped with a safety control system designed to protect against improper venting of combustion products.
∗ The 8003 must be installed in an existing masonry fireplace or Listed Wood Burning “0” Clearance Fireplace.
∗ 8004: This appliance may be installed directly on carpeting, tile or other combustible materials.
∗ This gas appliance must not be connected to a chimney flue serving a separate solid fuel burning appliance.
∗ Periodic examination of the venting systems is required.
∗ If the appliance is installed in the basement, please see local codes before using propane.
∗ USE ONLY THE GLASS DOOR CERTIFIED WITH THIS APPLIANCE
WARNING
IMPROPER ASSEMBLY AND/OR INSTALLATION OF YOUR BLAZE KING GAS APPLIANCE OR FAILURE TO OPERATE IT
ACCORDING TO THE GUIDELINES DETAILED IN THESE INSTRUCTIONS WILL VOID THE APPLIANCE WARRANTY, CAN
CAUSE A HOUSE FIRE, AND MAY ENDANGER YOUR FAMILY. FOR YOUR SAFETY, FOLLOW THE ASSEMBLY AND
INSTALLATION INSTRUCTIONS CAREFULLY. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS
AND INSTALLATION INSPECTIONS IN YOUR AREA. PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND
USE YOUR NEW APPLIANCE.
∗ Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.
∗ Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
∗ Young children should be carefully supervised when they are in the same room as the appliance.
∗ Clothing or other flammable material should not be placed on or near the appliance.
∗ Any safety screen or guard removed for servicing a room heater must be replaced prior to operating the appliance.
∗ Installation and repair should be done by a qualified service person.
∗ The appliance and venting should be inspected before use and at least annually by a qualified service person.
∗ More frequent cleaning may be required due to excessive lint from carpeting, bedding materials, etc.
∗ It is imperative that control compartments, burners, and circulating air passageways of the appliance are kept clean.
∗ To clean the stove, make sure the appliance is off and cold. Then remove the logs and embers and use a vacuum to clean burner and air
openings in the bottom of the appliance and also on the back of the appliance. Replace the logs and embers.
∗ The draft hood must be in the same atmospheric pressure zone as the combustion air inlet. The flow of combustion and ventilation air must
not be obstructed.
∗ Do not use this heater if any part has been under water. Immediately call a qualified service technician to inspect the heater and
to replace any part of the control system and any gas control which has been under water.
WARNING: FAILURE TO USE ONLY PARTS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY.
CAUTIONS
To Next Page
Loading...