BlueLine PowerCost Monitor - Default Chapter; Table of Contents

Table of Contents
1 Introduction...............................................................................4
2 Features.....................................................................................5
3 Safety Instructions ....................................................................6
4 Care and Maintenance...............................................................6
5 Installation ................................................................................7
5.1. Unpacking the PowerCost Monitor™ ...........................7
5.2. Powering the Display Unit ............................................9
5.3. Putting Batteries in the Sensor Unit.............................11
5.4. Determining your Utility Meter Type..........................11
5.5. Electromechanical Meter Installation..........................12
5.6. Electronic Meter Installation .......................................15
5.6.1. Top-Mounted Electronic Installation ................15
5.6.2. Side-Mounted Electronic Installation................18
5.7. Synchronizing the Display and Sensor Units...............20
6 Using the Display Unit............................................................23
6.1. Start-up........................................................................24
6.2. Dollar & Cents Display Mode.....................................25
6.3. Kilowatt and Kilowatt-Hours Mode ............................26
6.4. Temperature Display ...................................................27
6.5. Loss of Signal Display.................................................28
7 Display Settings......................................................................30
7.1. Display Unit Buttons...................................................30
7.2. Setting the Clock .........................................................32
7.3. Setting the Electricity Rate and Kh Factor ..................33
7.4. Resetting the Total Values...........................................35
7.5. Display Backlight........................................................37
7.6. Restoring Default Values.............................................37