EasyManuals Logo

BlueLine PowerCost Monitor User Manual

BlueLine PowerCost Monitor
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
After 2 minutes the Sensor Unit will stop flashing in order to maximize
battery life.
Once the Sensor Unit is properly mounted continue with section 5.7 –
Synchronizing the Display and Sensor Units.
5.7. Synchronizing the Display and Sensor Units
Your Sensor Unit comes pre-programmed with a unique ID code so it will
only work with your Display Unit. The Display Unit and Sensor Unit must be
synchronized before the system will function properly.
To synchronize follow these steps:
1. Make sure the display unit is on.
2. Press and hold the ID button on the back of the Display Unit until it
beeps (approx. 3 seconds). This will place the Display Unit into ID
Mode and it will begin to search for your Sensor Unit. You will see a
screen similar to the one shown in figure 5.12, below.

Other manuals for BlueLine PowerCost Monitor

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BlueLine PowerCost Monitor and is the answer not in the manual?

BlueLine PowerCost Monitor Specifications

General IconGeneral
BrandBlueLine
ModelPowerCost Monitor
CategoryMonitor
LanguageEnglish