3.6 Inverter Cables
Fault Code
B005.
B006.
B007.
B008.
B010.
B011.
B026.
B027.
B034.
Hardware BUS overvoltage
Hardware BUS2 overvoltage
Hardware Battery overvoltage
Hardware Inverter overcurrent
Hardware LLC1 current overcurrent input
Hardware LLC2 current overcurrent input
Hardware PV1 fault
Hardware PV2 fault
Hardware Overcurrent input
Please contact the BLUETTI support team.
Please contact the BLUETTI support team.
Please contact the BLUETTI support team.
TroubleshootingDescription
Picture Description Interface (connect to)
Red battery power cable (Positive)
Black battery power cable (Negative)
Generator communication cable
BAT+
BAT-
DRMs port
Turn off the inverter and wait 30
minutes to restart it. If the
symptom persists, please
contact the BLUETTI support.
Note: Please refer to Chapter 11. Troubleshooting for details.
Table 3-10 Fault Code
Table 3-11 Inverter Cables
JUST POWER ON28
To Next Page
Loading...
