JUST POWER ON 47
6.5 Install the IoT Controller
Danger
Make sure to check for any cables or pipes before drilling into the
wall.
To ensure a strong and uninterrupted wireless signal, it is recommended to install
the IoT controller in an open space, away from obstructions, and minimize the
distance between your home WiFi router and the IoT controller.
Avoid installing the IoT controller near steel-reinforced concrete or metal walls, as
these materials can interfere with WiFi and Bluetooth signals.
Step 1: Drill 2 pilot holes in the wall. Please refer to the drill position and hole size
shown in Fig. 6-6-1 and Figure 6-6-2. The depth of hole is 0.94in(24mm).
Step 2: Hammer the expansion wall plug in until it’s flush with the wall. See Fig. 6-6-3.
Step 3: Fix the mounting bracket onto the wall and use the cross screwdriver to
fasten 2 self-tapping screws into the wall plugs. See Fig. 6-6-4.
Step 4: Align the controller’s buckle over the U-slot and push the controller down-
wards until it snaps in place. See Fig. 6-6-5 and Fig. 6-6-6.
To Next Page
Loading...
