JUST POWER ON 43
23
22
Vacuum cleaner
Allen driver
6.3 Installation Requirements
6.3.1 Environment Requirements
•
Install the EP800 in a well-ventilated and spacious area to ensure good heat
dissipation.
• The EP800 has an IP65 rating and can be installed indoors and outdoors. Please
note that if you place the system outside the house, use a cabinet to protect it from
direct sunlight, as this may cause a degradation in system performance.
• The enclosure and heat sink are very hot while the inverter is working, therefore do
NOT install the inverter in places where you might touch inadvertently.
• Keep the EP800 away from flammable liquids, gases, or explosive materials.
• Keep away from children and pets.
• Do not install the EP800 outdoors in salt-affected areas, as the accumulation of salt
may corrode the system. Salt-affected areas are those within 500 meters from the
coast or susceptible to sea breezes. Salt accumulation is influenced by seawater,
sea breeze, precipitation, air humidity, topography and forest cover of adjacent sea
areas.
• Do not install the system in low-lying areas where water tends to accumulate.
Otherwise, water may leak into the equipment and result in system failure.
• Ambient temperature range: -4°F-104°F / -20°C-+40°C
• Relative humidity: 5%～95% (non-condensing)
• Maximum height: 6561ft / 2000m.
To Next Page
Loading...
